Performs visual and dimensional inspection to raw material received at Intuitive Mexicali Plant, by following applicable department procedures for Incoming Quality Control; to make sure raw material meets the specifications required by the products and manufacturing process for instruments and accessories.Documents inspection results to maintain traceability at Finish goods level.Safety:Follows GMPs and wears safety equipment to perform his/her endeavorsParticipates on Safety commission when required and/or safety trainingUtilize the correct tooling and equipment according to work instructions or inspection lot requirements, reporting any condition of wear off or damaged tooling or equipmentEscalates any safety issues with supervisor or managerFollows 5S methodology on the respective areasReports any safety device on equipment that is fault or is suspicious of been damagedQuality:Performs inspection to raw material at the IQC area and completes inspection report.Interact with computer-based software to assist on inspection activities and record inspection results.Document and execute TINS activities for VRs notification as required.Generates problem description presentation and upload to VR for engineering analysis.Creates VR Quality Notifications describing problem and inspection results when required.Performs and records First Article Inspection and route report for approvals.Performs Engineering requests activities and report results as required.Interpret basic mechanical drawings to understand dimensional inspection characteristics.Review supplier’s supplied documentation to evaluate it has the required information/test results per part drawings specification.Efficiency:Perform raw material inspection process on time and following procedures, move inspected material to required physical location based on lot disposition.Assigns location for material pending for IQC inspection by using IQC locator App.Records in SAP inspection decision for every inspected lotUpdates log files with daily activitiesCost:Propose and participates on improvement projects for the equipment or process under his/her responsibility or ISI PropertyPeople:Study and records all assigned curriculum by ISU (Intuitive Surgical University)Creates self-evaluation for CIP and MERITFollows ISI Policies, Rules and code of conductProductivity:Meet daily average goal for inspection lots based on SAP.Proficient on the use of basic standard inspection tools/equipment as calipers, micrometers, pin/block gages.Comply with efficiency metrics defined by the department management.
